PLEASE, BEFORE YOU PERHAPS WISH TO PRINT THIS FILE ASK YOURSELF IF YOU COULD POSTPONE THAT THOUGHT !
IT MIGHT STRIKE YOU AS SMALL AND SYMBOLIC GESTURE FROM YOUR BEHALF, BUT EVERY ACTION COUNTS. WE MUST START FROM SOMEWHERE !
PLANET THAT IS OFTEN CALLED AS WATER PLANET IN 2006. HAS 3% OF DRINKABLE WATER (NO TYPO) ISN'T THAT IRONIC?
WE NEED AIR EVEN MORE THEN WATER, CONSIDER THAT EVERY PAPER SAVING ACTION CONTRIBUTES TO LESS PAPER CONSUMPTION, THUS THREES AS SUCH !
RESPONSIBILITY IS THE ESSENCE IF YOU CONSIDER NEXT GENERATIONS, THOSE OF YOUR OWN KIN, YOUR CHILDREN, THOSE THAT INHABIT THE WOODS : ANIMALS.
SO READ THIS SCREEN IN NORMAL 030 MODE OR SAVE IT AS WEB PAGE ON YOUR OWN OS MACHINE.
IMPORTANT : Don't ask assistance from me if you didn't read this !
Material Overview :
The CT60 offers two modes : 030 and 060. The 030 mode (CT60 OFF) permits to keep a Falcon 100% as origin. With 060 mode (CT60 ON), it is too possible to boost the Falcon motherboard with some solders.
Features (in MHz) table of the different settings
CT60 OFF CT60 ON CT60 ON FITTING SOLDERS & NO SOLDERS NO SOLDERS SOLDERS CPU 030@16 060@66 060@66 FPU 882@16 or 32 060@66 060@66 BUS (F30/CT60) 16/OFF 16/66 25/66 DSP / VIDEL 32 32 50
The modes CT60 ON with solders at 50 MHz are available in VGA standard & extended résolutions. To use the RGB & ST-MONO (SM12x/144), a 32 MHz clock must be added on the VIDEL pin#14 input (EXT). This clock should be taken from the 32 MHz oscillator at left of the DSP.
Software Overview :
The Hard Disk boot must be done with HD Driver 7.60 (or higher) or CECILE 2.18 (or higher). Don't use the old HDD drivers like AHDI, ICD & SCSITOOLS (HUSHI) if you want to not destroy your HDD partitions !
Cecile is not working with SCSI HDD and 060 !
External software :
Here is the order you must respect into the AUTO folder (use AUTOSORT prg). This is only indication because some of them can't be together !
- DRVIN (replaces Fpatch2)
FILEINFO.CPX is an utility permitting to adjust 3 bits of program configurations and accessories: FastLoad, TT-Ram (Mem) and TT-Ram (Prg).
The FastLoad bit prevents the system to erase all the memory to every launching of the software, that can take time with 64 MB of Fast-Ram.
The TT-Ram bit (PRG) loads the program in Fast-Ram, attention to the software audio and video (by example : CUBASE AUDIO will not output sounds if the PRG bit is set ! But you should set the MEM bit).
The TT-Ram bit (MEM) fact that the program will make this allowances memory in Fast-Ram, same remark for the program.
Some software need a patch or to be replaced by a patched version. It is the case with Cubase Audio that needs a patch present in the software package.